WCM Black-Ops division presents the Servo Saver Saver

WCM developed this system to to enhance the standard HD servo saver used in nearly all 1/4 scale RC cars.  The system addresses the two main failiure modes of the standard servo saver.  This kit uses a specially machined "washer" that captures an o-ring and ties together the axle of the servo saver to the arm component, increasing the resistance of the assmebly and reducing the stress that the spring undergoes.  This allows for a more direct feel all while still providing much more servo protection that a fixed arm or pinned servo saver.  The user can adjust the feel of the assmebly by lubricating the o-ring (reccomended) or running it dry for the most agressive feel.  the second component of the kit addresses the other comomon failure mode with a carbon fiber doubling plate that get bolted to the arm portion of the servo saver reducing the potentional for those common breaks.

The kit includes:

2x Specially machined aluminum washers annodized red

2x Carbon fiber doubling plates (also serves as a drill jig)

2x Kimbrough HD servo savers

4x Red aluminum 4-40 nuts and bolts for carbon plate

2x viton o-rings

2x 3mm servo bolts

2x 2.5mm servo bolts

Will fit any servo that uses either 3mm or 2.5mm spline bolts and has been succesfully fit to WCM and TNT cars and should not have any trouble fitting others.

***Disclaimer***

This kit is designed with the serious racer in mind. The servo saver saver strenghtens the entire servo saver assembly and could consequently cause damage to your servo in a serious crash.  if you are a serious racer and performance is paramount, then this kit is for you.

TYJDP